I was using two of :
One was OSC_A, other OSC_B
But the OSC_B was a copy of OSC_A and after moving this one, connect to to the desired audio source i renamed it to ..OSC_B.
But while doing other things i noticed that my oscilloscope was not working on OSC_B and the output of OSC_B was send to the oscilloscope for OSC_A.
I found out that when i disconnected:
And reconnected it again, it was working as intended.
Since i don’t now exactly what i did, the steps to connect this i can assume two ways:
A) I connected it before renaming or B) renamed it and then connected it.
I thought i did A) but i consider B) also because sometimes that is my normal workflow.
