Bug Report : Sig Gate/Oscilloscope bug

I have a project that i’ll share where the sig gate kinda works as intended but I think a visual bug is happening with the oscilloscope causing some misinformation I think.

Basically in short: when I have my project in “singleband mode” the Waveshapers from “Multiband mode” are still affecting the oscilloscope when not enabled.

Trash 2 at home help.mnprtz (134.3 KB)

From what I can see, that is generating a DC offset. In this case, to prevent both signals from overlapping, place the gates after the waveshapers, not before them.

By the way, I couldn’t help myself, besides changing the gate setup, I also tidied up the patch a bit.

Trash 2 at home.mnprt (81.4 KB)

Thank you so much! I really appreciate the help :folded_hands: