Allow cable connection from cable joints

This idea comes from comfyui again. It is really useful to keep cables tidy and have an organized graph. It’s also pretty handy to make distances for cable connections short.

See here:

Was just thinking, one of the pass through nodes might get you close in the interim.

Hm, no. I believe this suggestion here is something else and does not need any nodes at all. It just re-uses the joints in a clever way to allow more connections in the graph.

The passthrough node would allow 1->1, 2->2, 3->3 … cables per node + enable flag. It uses same number In/Out pairs. This suggestion here allows 1->n connections but in a different way than currently (using the joints). :slight_smile:

Your suggestion is a reasonable request imho. I was just suggesting a pass through node which also gives you 1->n may come close to what you need “in the interim” until such time your request is perhaps implemented.

I’ll always throw ideas out there to potentially help people. Maybe 1 in 5 will be helpful if I’m lucky. I’m sorry this one fell within the 4 in 5 fail zone :slight_smile:

This is what I had in mind (there is also a node like this for audio signals):

Its similar to the pass through node i think, but this is much much nicer. Could you have more branches along the length of a wire too by adding nodes along it? That would go a long way to cleaning up the dropped spaghetti I create sometimes. Great suggestion!

I was thinking the exact same thing.