I have a quite simple synth built here, just to get to grips with MNodes really.
I’ve hit a point where it sounds great and does what I’d like it to but now I want to add some modulators. Nothing fancy, a couple of LFOs and an Envelope or 2. But I can’t seem to find the right documentation to help me build assignable modulators.
Could someone point me in the right direction here?
Secondly, is there any inbuilt way of lowering output level to match a signal level earlier in the audio chain?
I have some saturation, clipping and transient options which all push the signal a bit hotter than I’d like.
The actual tone of the clipper is why I’ve used it, more as a distortion than to control the signal level, so ideally, I’d like to map the signal pre-saturation & clipping after the clipper at the output phase.
point 1 has many approaches you could use gates or also sends it depends what you want and if you only need 1 lfo or more
some point 2 autogain basics:
1 get the highest pre of l/r using a meter and max
2 get the highest post of l/r using a meter and max
3 subtract the 2 outcomes
4 apply the difference to a volume node (in db mode) that sits just before the output meter
Ideally, I’d like to have at least 2 LFOs and an envelope that could be assignable to multiple sources at once, or individually.
I only have a handful of points that I’d like to modulate, about 15 in total but it would be nice to set a single envelope to filter cut off and saturation amount simultaneously for example.
Ideally a drag & drop, with ring amount to show modulation (options for positive & negative ranges) but if it’s too hard to do that, I’m also happy with a mini-matrix style modulation system.
If it’s possible to have a drop down menu with sources and then a range knob/slider, that would also work out. I’d just have to be a bit more selective on how many controls could be modulated per source.